Semi Automatic Flat Labeling Machine Used Mobile Phone / Cameralens
/ PCB Board
HL-T-101 Applicable to all kinds of precision prodcuts on the plane
labeling change the label suction head to meet the small size
labeling. Such as the diameter of 5mm tag labeling.
installation of X/Y -axis feed mechanism or bidirectional drive
wheel feed mechanism, the products of automatic feeding, feeding
speed upgrade.accuracy to ±0.2mm,Such as:USB
connector,Rubiks's cube,mobile phone charger,cameralens, PCB board
and other prodcuts labeling.
|Applicable Dimensions||Length:20-200mm Width:20-180mm Hight:0.2-65mm|
|Machine Size(LxWxH)||About 550*420*780mm|
|Delivery Time||10 Days|
|Shipping Method||Sea.Air and Express|
|Payment Term||L/C,T/T,Money Graml etc|
Common Faults Solutions
1.The breakage of backing paper: The backing paper breakage is
closely related to the three factors: the quality of the label
backing paper, the scratching of the backing paper in the label
traction route, and the label adhesion.
2. condition, if it has cut damage, you will need to use high
quality backing paper. It is recommended to use Glassine paper.
3. Check the label whether it is scratched on the threading way ,
and eliminate the factors of scratch.
4. If the label is adhesive, the label is easy to tear. Control the
out-light length of next label and ensure that it would not adhered
to the labeled product, that is OK.
5. The labeling deviation exceeds the accuracy requirements: the
labeling deviation has relations to the following factors: label
tape moving deviation, the direction of the label tape and the
product conveying direction are not parallel, the traction wheel
slips, the product positioning detection is inaccurate, and the
label is not attached tightly to the product along with the label
overlay wheel, or the product deviation. Check the above factors,
and then targeted solutions.
6. Label tape moving deviation: loosen the traction mechanism and
pull the label back and forth to get it to go properly. After the
label is straight down, clamp the limit rings on both sides and
align the labels
7. The traction wheel slips: Traction wheel slips, traction wheel
abrasion are related with traction wheel screw lock or loose, both
of them can be solved by tighten the traction wheel and Locking
8. Product deviation: during the labeling process, the products’
edges deviation will cause the labeling deviation, this problem has
to be settled by controlling the quality of the product .